![]() With the supplied rollover cable, insert the RJ-45 connector into the console port.Īttach the supplied RJ-45-to-DB-9 female DTE adapter to a PC or attach an appropriate adapter to the terminal. To connect the PC or terminal to the switch:īe sure that you have configured your PC or terminal emulation software to communicate with the switch via hardware flow control.Ĭonfigure the baud rate and character format of the PC or terminal to match these console port default characteristics: The terminal emulation software-frequently a PC application such as Microsoft Windows HyperTerminal or Symantec Procomm Plus-makes possible the communication between the switch and your PC or terminal during the setup program. The PC or terminal must support VT100 terminal emulation. You can order a kit (part number ACS-DSBUASYN=) that contains the adapter from Cisco. ![]() ![]() You need to provide an RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal. Use the supplied rollover cable and the DB-9 adapter to connect a PC to the switch console port. This document focuses on use of the default parameters to connect and configure management terminals. Conventionsįor more information on document conventions, refer to the Cisco Technical Tips Conventions. If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. To identify the type of cable you use, refer to Configure Cable Requirements for Console and AUX Ports. Rollover cables and straight-through cables have pinouts that are different than crossover cables, which can connect 10/100BASE-TX Ethernet ports between switches. The cable you use depends on the type of Supervisor Engine and other factors. These switches require the use of either a rollover or straight-through RJ-45 cable to connect a terminal to the console port. There are no specific requirements for this document. This document describes how to use the default parameters to connect and configure management terminals.
0 Comments
Leave a Reply. |